Alloys: Zamak 5 (ZL5, ZL0410, ZnAI4Cu1, alloy 5)
View
Second Place, 2018 EU Zinc Die Casting Competition This part can be easily installed on site using clips with clamping ribs with a power input of 65 to 75 N. Predetermined breaking points with a defined break at 360 to 460 N allow disassembly if required. To ensure...
View
Excellence Award Winner from China Best Diecasting 2018 This part has a moderate complexity and an excellent surface finish after plating. Most interesting is the unusual application in high speed trains, which is a segment where lower series volumes can be expected....
View
Excellence Award Winner from China Best Diecasting 2018 This part has a high level of fine detail and an excellent surface finish after plating. It is difficult to cast and ejection needs to be done carefully to avoid any deformation. The casting process is very...
View
Gold Award Winner from China Best Diecasting 2018 This part was an existing part already but brass has been substituted by Zamak5 alloy. It is thin wall, min 0.5mm, and electroplated, so it has high surface requirements for surface roughness, cold shuts, and...
View
Together, these two parts form a protective casing for the internal components of traffic lights. The material properties provide protection against vandalism and have much longer lifetimes than polymer materials. Due to thinner sections, they are also lighter than...
Page 6 of 14« First«...45678...»Last »
